ENGLISH
30
Dubbing the audio and video signals separately onto VIDEO 1
Example) When dubbing the VIDEO 2 video signal and the CD audio signal separately onto VIDEO 1.
NOTE: When selecting a video recording source and an audio recording source respectively, press the input selector buttons
on the remote control, not the “Source /” buttons on the front panel.
1. Select VIDEO 2 as a video recording source. 3. Start recording on the VIDEO 1.
2. Select CD as an audio recording source. 4. Start play on the VIDEO 2 and the CD respectively.
• The audio signal from the CD and the video signal from
the VIDEO 2 will be dubbed and you can enjoy them on
the TV set and from the speakers.
NOTE : Be sure to observe the order of the above steps 1
and 2.
To Next Page
Loading...
