Page 48
CDi DriveCore Series Operation Manual
Using HiQnet Audio Architect
To open a preset or device le in Audio Architect:
1� Go online with the device. You must be online for the settings to be sent down to the actual device. See "Going Online" on page 33 for
instructions on going online.
2� Open the Main CDi DriveCore Control panel.
3� Select "File | Open | Device File” to open a device file. Or, select "File | Open | Preset File” to open a preset file.
4� If opening a device file, proceed to the next step. If opening a preset file, the below window will appear. From the "Load into preset:" dropdown menu,
select the preset location to which you wish to load the preset. Click Select, navigate to the folder containing the preset file, select the file, then click
Open. Now click OK. The preset file has now been loaded.
5� When the Open prompt appears, navigate to the folder containing the device file, select the file, then click Open. The device file has now been opened
and all presets and applicable settings will be reflected in the device.
To Next Page
Loading...
Need help?
General