Harmonic Electra9200 - IP Input and Output Support and Specifications

Chapter 4 Electra 9200 Specifications Audio Encoder Features
© 2015 Harmonic Inc. All rights reserved. 33 Electra 9200, Rev O
Encapsulation mode is controlled by selecting “MP EG-2” or “MPEG-4” as required.
IP Input and Output Support and Specifications
The IP Input on the chassis provides a Transport Stream input to the FLEX Decoder Module
from an IP network. Dual GbE IP inputs support various input redundancy configurations.
Table 4–7: IP (GbE) Input
Feature Support
Type Gigabit Ethernet
IP ports Two independent ports
Connector Two × RJ-45 ports
Speed One × 10/100/1000 Mbps per port
IP encapsulation MPEG-2 TS over UDP/IP 1 to 7 TS/ IP
MPEG format 188 or 204 bytes per TS packet
MPEG-2 TS MPTS and SPTS
Maximum Bit-Rate per
Socket
100 Mbps
Addressing Unicast and multicast
Management IGMP, ARP, and ICMP
Forward Error Correction
(FEC)
The GbE input supports SMTE 2022-1 and -2 forward error
correction (FEC). FEC provides lost packet recovery at the
receiving devices.
Table 4–8: IP (GbE) Output
Feature Support
Type Gigabit Ethernet
IP ports Two independent ports
Connector Two × RJ-45 ports
Speed One × 100/1000 Mbps per port
IP encapsulation MPEG-2 TS over UDP/IP 1 to 7 TS/ IP
MPEG format 188 bytes per TS packet
MPEG-2 TS MPTS and SPTS
Maximum Bit-Rate 180 Mbps
Addressing Unicast and multicast
Management IGMP, ARP, and ICMP