Contents
© 2015 Harmonic Inc. v Electra 9200, Rev O
Contents
Introduction.............................................................................................1
Manual Organization .................................................... 1
Chapter 1: Electra 9200 Overview.........................................................3
Encoder Description .................................................... 3
Front and Back Panels ................................................ 4
Optional Modules ....................................................... 5
Features Overview ...................................................... 6
Chapter 2: Installing the Encoder..........................................................8
Preparing the Encoder................................................... 8
Installing the Encoder in a Rack ........................................... 8
Rack Guidelines ...................................................... 9
Chassis Warnings for Rack Mounting and Servicing ........................ 9
Airflow ............................................................10
Attaching the Rack Rails ..............................................10
Mounting the Encoder ...............................................11
Cabling the Encoder....................................................12
Connecting the Video Input Cables .....................................12
Connecting the IP Output Cables ......................................12
Connecting the IP Input Cables ........................................13
Connecting the Ethernet Management Cable ............................13
Connecting the Fault Relay/General Purpose Interface (GPI) Ports ...........14
Connecting the Serial Data Port ........................................15
Cabling Optional Modules ...............................................15
Connecting the Power ..................................................15
Connecting an AC Power Supply .......................................15
Connecting the DC Power Supply ......................................16
The Boot Sequence ....................................................19
Local Control Panel Display Messages during Bootup .....................19
Messages When Resetting the Encoder .................................20
Front Panel LEDs ......................................................20
Back Panel LEDs.......................................................21
Main Board LEDs ....................................................21
Video Lock LEDs ....................................................22
Chapter 3: Operating the Encoder...................................................... 23
Operating with NMX Digital Service Manager ...............................23
Operating in Standalone Mode ...........................................23
Using the Front Panel ..................................................23
Front Panel Keypad ..................................................23
Front Panel Display ..................................................24
Licensing Information...................................................25
To Next Page
Loading...
