24 HMX6801+B2/C2 and HMX6801+B4/C4 Installation and Operation Manual
Chapter 3: Operation
OverWrt Attempts to overwrite existing audio data and control
packets of the same group number with the new audio data
(This setting is valid only if the audio group to be
embedded already exists.)
In this setting, if the new sample distribution does not
exactly match the existing audio data packet sample
distribution, the embedder will mark some audio data
packets for deletion (DID word will be set to 180h).
To avoid sample distribution issues, enable the ADS
Clean feature.
See Figure 3-3 on page 27 for more information on
OverWrt embedding mode.
Auto Attempts first to overwrite existing audio data and control
packets of the same audio group number; failing that,
appends the new audio data and control packets
immediately following the last existing audio data/control
packet
Refer to the G1Exists, G2Exists, G3Exists, and G4Exists
parameters to determine what audio groups are already
present in the incoming SDI signal.
Table 3-1. Embedding Mode Options (Continued)
Options Description
To Next Page
Loading...