Harris HMX6801+B2/C2 - ADS Clean Parameter; Channel Dithering

36 HMX6801+B2/C2 and HMX6801+B4/C4 Installation and Operation Manual
Chapter 3: Operation
ADS Clean Parameter
Depending on the setting of the ADSClean parameter, the EMB1Mode
and EMB2Mode parameters will have different options.
Channel Dithering
When any audio output channel is of a Non-PCM format
(Output Chxx Format=Non-PCM or Output Chxx Format=Auto
and Out Chxx Format Fb=Non-PCM), the Dithering feature for that
channel pair (1-2, 3-4, etc.) is disabled, even if only one channel of the
pair is Non-PCM. Both channels in the pair must be of a PCM format
for the Dithering feature for that channel pair to be re-enabled.
For example, if Output Ch01 Format is set to Non-PCM (or Output
Ch01 Format=Auto and Out Ch01 Format Fb=Non-PCM), then
output channel pair 01-02 has dithering disabled (Out 01-02 Dithr
Mode is set to None and the parameter is disabled), even if Output
Ch02 Format is PCM. If both Output Ch01 Format and Output
Ch02 Format are changed to PCM, then the Out 01-02 Dithr Mode
parameter is re-enabled.
Table 3-7. ADS Clean Parameter
ADSClean state
EMB1Mode and
EMB2Mode Options
Yes
•Off
• Append
No
•Off
• Append
• OverWrt
• Auto