Maintenance 1B30E, 1B50E / 02 - Rev. 01
62
HATZ
Manual
Step Activity Figure
2 Pull the oil filter(2) out of the
housing.
3 Blow out the oil filter from the
inside to the outside with com-
pressed air.
4 Check the gaskets (3+4) for
damage and renew if neces-
sary.
5 Lightly oil the gaskets before
installation.
6 Insert the oil filter and press it
all the way in.
7 Before tightening the screw,
ensure that the tension
springs(5) rest against the oil
filter at both ends.
Tighten the screw.
8 Check the oil level and add oil
to the max. mark if necessary
(see chapter 7.5 Check the oil
level, page 45).
To Next Page
Loading...
