5
Clip
HBMA0114-6.3 en
Residual dangers
The Clip Electronic scope of performance and supply covers part of the mea-
suring-technology, only. The plant designer/constructor/operator must in addi-
tion design, realize and take responsibility for the measuring-system’s safety
such that potential residual dangers are minimized. The respective regulations
must in any case be observed. Residual dangers regarding the measuring
system must be specified explicitly.
If there is any risk of remaining dangers when working with the, it is pointed
out in this introduction by means of the following symbols:
Symbol:
DANGER
Meaning: Maximum danger level
Warns of an imminently dangerous situation in which failure to comply with
safety requirements will result in death or serious physical injury.
Symbol:
WARNING
Meaning: Dangerous situation
Warns of a potentially dangerous situation in which failure to comply with
safety requirements can result in death or serious physical injury.
Symbol:
CAUTION
Meaning: Potentially dangerous situation
Warns of a potentially dangerous situation in which failure to comply with
safety requirements could result in damage to property or some form of
physical injury.
To Next Page
Loading...
