Connections and displays
26 A3169-8.0 HBM: public CX22B / CX22B-W
Status LEDs for digital outputs
The LEDs show the status of digital outputs 4 to 6. The
outputs are addressed via LEDs 4 to 6 in catman
EASY.
Set the outputs via limit value and event monitoring: En
ter 0 HIGH (LED 4) for Bit/Condition if output 4 is to be
active when the event occurs (LED 4 lights up green).
Outputs 5 and 6 are activated via bit 1 (LED 5) and bit 2
(LED 6).
The corresponding digital output is simultaneously
triggered in LEDs 4 to 6. The LEDs light up when the rel
evant output is set to HIGH.
LED for the operating condition of the CF card
The LED on the rear of the module flashes yellow when
data are written to or read from the CF card.
To Next Page
Loading...
