HBM QuantumX CX22B - First DAQ Job with catmanEASY; Creating a DAQ Job

The first DAQ job with catman

EASY
CX22B / CX22B-W A3169-8.0 HBM: public 53
8 The first DAQ job with catman

EASY
Launch catman

EASY in the start screen.
► Run a device scan
► Select the required devices.
8.1 Creating a DAQ job
A DAQ project contains all the settings for the devices,
transducers (sensors) and calculations used, how the
measurement is to be carried out, and which data should
be visualized online and saved.
Setting up DAQ channels
If you are not using transducers with TEDS (Transducer
Electronic Data Sheet) assign the connected sensors
(transducers) to the channels: find your sensors in the
sensor list (Sensor database component window), then
drag&drop each sensor to the channel to which it is con
nected. Set up your sensors in the sensor database, as
required.
Assign unique channel names
You can generate channel names with sequential
numbering or accept the sensor designation via the Re
name context menu. In catman

EASY, each channel is
identified by its name, so you must use meaningful
names where possible.
► Mark the channels to be set to zero and run a zero
balance (zero balance, group zero balance).