HDFury Integral 2 - Page 48

Disclaimer: 3
rd
party and/or custom firmware providing extra features are not covered in this manual.
48
4K Integral 2 – User Manual
RING = RX [receives data to Integral 2]
SLEEVE = GND
Parameters: 19200, n, 1, no handshake
Every command must start with # character and must end with a carriage return \r or a newline \n
Use only lowercase characters
Example commands:
#get edidmode
#get hdrcustom
#set edidmode automix
#set hdrstr 87:01:1a:b0:02:00:c2:33:c4:86:4c:1d:b8:0b:d0:84:80:3e:13:3d:42:40:a0:0f:32:00:e8:03:90:01
#set hdrcustom on
#set avistr 82:02:0d:ae:40:c0:60:61:00:00:00:00:00:00:00:00:00
#set avicustom on
#set vsistr
81:01:1b:63:00:00:00:00:00:00:00:00:00:00:00:00:00:00:00:00:00:00:00:00:00:00:00:00:00:00:00
#set vsicustom on
#set cecstr 0f:36
Command list:
#get ver shows the current Integral 2 FW versions
#get status x shows the current status for the requested info
x can be rx0, rx1, tx0, tx1, tx0sink, tx1sink, aud0, aud1
#get audiochbot
#get audiochtop
Returns the audio mode LPCM / bitstream from the selected input
#set hotplug Issue hotplug event to the sources
#set input x / #get input
Change the input port. x can be top/bot/thru/swap
#set autosw x / #get autosw
Toggle the input port auto switching capability.
If on, the input port will change to an active input if the current input is switched off.
x can be on/off
#set autoswprio x / #get autoswprio
Toggle the input port auto switching priority.
If on, the input port will force change when a new source is connected.
x can be on/off
#set scale x / #get scale
Change the scaling mode if the scale-slide switch is in the middle position.x can be auto/custom/none