3
80-23024 Issue 3r1 HEBER
You will also have a short USB cable (black or white) and Ethernet patch cable (yellow).
Please note that a fittings pack (shown below) is not included if you purchased a board only, but is
available as a separate item to buy from the RMCretro Shop.
The fittings pack is included if you purchased a 3D printed enclosure from the RMCretro Shop or a
deluxe kit.
The fittings pack is intended to be used with the 3D printed enclosure reference design, if you are
fitting the Multisystem into your own enclosure or have designed your own case, you may find the
fittings pack useful, but it is not essential unless you intend to use the reference design enclosure.
All the following instructions in this user manual below assume you have ordered a Multisystem with
3D printed enclosure, they use the standard fittings pack.
To Next Page
Loading...