Ch. 1 GENERAL INFORMATION
1-6
Rubber and plastic boots should be properly reinstalled to the original correct positions
as designed.
The tool should be pressed against two (inner and outer) bearing races when removing
a ball bearing. Damage may result if the tool is pressed against only one race (either
inner race or outer race). In this case, the bearing should be replaced. To avoid
damaging the bearing, use equal force on both races.
Before battery removal operation, it has to remove the battery negative (－) cable firstly.
Tools like open-end wrench do not contact with body to prevent from short-circuit and
create spark.
After service completed, make sure all connection points is secured. Battery positive (+)
cable should be connected firstly. And the two posts of battery have to be greased after
connected the cables.
If fuse burned, it has to find out the cause and solved it. And then replace with specified
capacity fuse.
To Next Page
Loading...
