22
6. Tyres - check condition and pressure
(page 20-21)
8. Drive chain - check condition and
slackness (page 40-42). Adjust and
lubricate if necessary.
10. L a m p a n d h o r n - c he ck t h a t
headlamp, tail/stop lamp, turn signal,
lamps and horn function properly.
12. Air suction valve - make sure all tube
connections are secured properly
(page- 54).
5. Front brake (Disc type) - check for
correct brake fluid level in the master
cylinder (page 43-45).
7. Clutch - check for smooth operation.
Adjust free play (page 38-39).
9. Throttle - check for smooth opening
and closing in all steering positions
(page 36).
11. Rear view mirror - ensure that the rear
view mirror gives a good rear view
when you are sitting on the motorcycle.
15. Steering - check for smooth action and
for easy maneuverability.
13. Fitting & fasteners - check & tighten
if necessary.
14. Battery - check voltage (page 46-48).
1. Engine oil level - check and top up
engine oil if required (page-18-19).
Check for leaks.
2. Program m e d FI Ma l f u n c ti o n
Indicator Lamp - when the ignition
switch is turned "ON" the Programmed FI
Malfunction Indicator Lamp glows for a
few seconds and then it should go "OFF".
3. Fuel level - ensure sufficient fuel is
available in the fuel tank for your journey
(page 13-14, 17). Check for leaks.
4. Front and rear brakes (Drum type) -
check operation. Adjust free play if
necessary (page 42-43, 45-46).
-
To Next Page
Loading...
