2
3
15
(1) Electric starter switch (2) i3s switch
1
3. Horn switch ( )
Press the horn switch (3) to operate the horn.
(1) Dimmer switch
(2) Turn signal lamp switch (3) Horn switch
1. Electric starter switch ( )
Ensure starter switch (1) is operated when the
vehicle is in neutral gear. If the vehicle is
engaged in gear press the clutch lever before
operating the starter switch. Release starter
switch after the engine has started.
Right handlebar controls
•
If electric starter switch is pressed
continuously and engine does not start,
cranking of engine will stop after 5 secs.
After that rider again needs to press the
electric starter switch.
•
If engine started, cranking of the engine will
stop after r/min reaches more than 1000.
CAUTION
!!
There is an i3s switch provided to enable (2)
the rider for turning i3s mode “ON” or “OFF”
based on the traffic conditions.
2. i3s switch
2
(4) Clutch switch
4
4. Clutch switch
There is a clutch switch (4) provided for the
safety of the rider. The vehicle cannot be
started by electric starter switch until the clutch
lever is operated when the vehicle is engaged
in gear.
1
To Next Page
Loading...
