EasyManua.ls Logo

HERO SPLENDOR+ PROGRAMMED FI - Starting Methods and Issues

HERO SPLENDOR+ PROGRAMMED FI
70 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4
22
If the engine fails to start after repeated
attempts, it may be flooded with excess fuel.
Open the throttle fully.
Ÿ If the engine starts with unstable idle,
open the throttle slightly.
(Bank angle sensor cuts off the ignition).
Ignition cut off
Your vehicle is designed to automatically stop
the engine fuel pump, if vehicle falls down.&
Ÿ If the engine does not start wait for 10
seconds, then follow first 3 step again.
Flooded engine
Follow the normal starting procedure.
Press the starter switch for 5 seconds.
(4) i3s switch
NOTE
If the vehicle has fallen down, before restarting
the engine you must turn the ignition switch to
"OFF" ( ) position and then back to "ON"
( ) position.
Electric start: Press the starter switch with
fully closed throttle.
Kick start: Depress the kick starter until
resistance is felt. Then let the kick starter
return to the top of its stroke. Kick from the
top of the stroke through to the bottom with
a rapid, continuous motion.
Starting procedure
At any ambient temperature, Press the starter
switch with the throttle completely closed.
NOTE
If you plan to ride your vehicle at an altitude
above 2000 meter, consult for advice at
Authorised Hero MotoCorp workshop.
While the vehicle is operated at an altitude
above 2000 meter, you may not achieve
sufficient engine performance. Please visit
your Authorised Hero MotoCorp workshop.
The engine will not start if the throttle is
open because the Electronic control unit
(ECU) cuts-off the fuel supply.
Make sure whether the i3s switch (4) is in
“ON” or “OFF” position.
Ÿ Find neutral position & check neutral
N indicator (3) on instrument console
with ignition "ON".

Related product manuals