15
There is a clutch switch (2) provided for the
safety of the rider. The vehicle cannot be
started by electric starter switch until the clutch
lever is operated when the vehicle is engaged
in gear.
2. Clutch switch
The headlamp operates only when the engine
is running or when passing switch is operated.
3. Headlamp dimmer switch
Select “ ” for high beam and “ ” for
low beam.
(1) Passing switch (2) Clutch switch
2
IMPORTANT: To switch “OFF” the turn
signal after completing the turn, gently push
inside.
4. Turn signal lamp switch ( )
Shift the turn signal lamp switch (4) sideways
for right/left indications and leave it to come
back to its normal position on its own.
1
5. Horn switch ( )
Press the horn switch (5) to operate the horn.
1. Electric starter switch ( )
Right handlebar controls
Ensure starter switch (1) is operated when the
vehicle is in neutral gear. If the vehicle is
engaged in gear, press the clutch lever before
operating the starter switch. Release starter
switch after the engine has started.
5
(3) Headlamp dimmer switch
(4) Turn signal lamp switch (5) Horn switch
3
•
If engine started, cranking of the engine will
stop after r/min reaches more than 1000
r/min under normal condition.
•
If electric starter switch is pressed
continuously and engine does not start,
cranking of engine will stop after 5 secs.
After that rider again needs to press the
electric starter switch.
CAUTION
!!
4
To Next Page
Loading...
