HERO SUPER SPLENDOR PROGRAMMED FI - PRE-RIDE INSPECTION; Essential Checks Before Riding

21
• Rear brake (For IBS)-Check for correct
brake fluid level in the reservoir (page 44).
• Tyres-Check condition and pressure
(page 52).
• Clutch-Check for smooth operation.
Adjust free play if necessary (page 39).
• Rear brake- Check operation. Adjust free
play, if necessary (page 46).
• Drive chain-Check condition and
slackness (page 40). Adjust and lubricate if
necessary.
• Lamps and Horn-Check that headlamp,
tail/stop lamp, turn signal lamps and horn
function properly.
• Rear view mirror-Ensure that the rear
view mirror gives a good rear view when you
are sitting on the vehicle.
• i3s switch-Make sure whether the i3s
switch is in “ON” or “OFF” position
(page 16).
• Throttle-Check for smooth opening and
closing in all steering positions (page 40).
• Fitting & Fasteners-Check & tighten if
necessary.
• i3s system-Make sure that i3s system is
functional properly (page 16).
• Steering-Check for smooth action for
easy maneuverability.
•
Engine oil level-Check and top up engine
oil if required (page 32). Check for leaks.
•
Programmed FI malfunction indicator
lamp (MIL)-When the ignition switch is
turned “ON” the programmed FI
malfunction indicator lamp(MIL) glows
continuously and then should go “OFF”
once the engine is started.
•
Fuel level-Ensure sufficient fuel is available
in your fuel tank for journey. Vehicle should
not be operated with fuel gauge needle at
red band continuously (page 14). Check
for leaks.
• Front and Integrated brakes (Drum
type)-Check operation. Adjust free play if
necessary (page 45).
You should conduct pre-ride inspection
before riding the vehicle to enhance riding
comfort and safety. Clean your vehicle
regularly. It protects the surface finish. Avoid
cleaning with products that are not specifically
designed for vehicle surfaces. Inspect your
vehicle very day before you start the engine.
The items listed here will only take a few
minutes, and in the long run they can save
time, expense and possibly your life. Please
follow the tips as given below:
PRE-RIDE INSPECTION
•
Front brake (Disc type)-Check for
correct brake fluid level in the master
cylinder (page 43).