Short Cuts
a. Set All
When setting up an irrigation program, the “Set All/Auto Disable” key allows a quick method of setting a
number of zones to run for the same length of time.
Go to the program set up screen where zone times are entered.
To set a group of zones to the same run time, press “Set All”.
Enter the range of zones to be set to the same run time.
The zone range is specified in terms of the row number of a zone in the irrigation program. The row number
of a zone is displayed in the top right hand corner of the program screen when the cursor is positioned on that
zone.
Enter the run time in minutes and seconds for the range of zones selected.
Press the MENU or “Set All” key to return the program editing screen.
b. Manual Advance
When an irrigation program is running, press the “Arrow Right” key to move onto the next zone in the
sequence. This can be useful when testing your system.
PROG 1 R001 C1-2
1 ZONE 01 VALVE 1 0:00
2 ZONE 02 VALVE 2 0:00
3 ZONE 03 VALVE 3 0:00
4 ZONE 04 VALVE 4 0:00
5 ZONE 05 VALVE 5 0:00
SET ALL
---------------------------------
FROM ROW 001 to 001
RUN TIME TO 0:00
--------------------------------------------
To Next Page
Loading...