If the “Auto Disable” key is pressed when the Time screen is displayed, then “AUTO START DISABLED”
will be displayed and all automatic starts immediately disabled. Programs will not run.
Press the “Auto Disable” key again to reactivate automatic starts.
13. Zone Info.
Set this option to 001 to display “ZONE INFO” in the Main Menu.
Once all zone information has been entered this option can be set to 000 or N to remove “ZONE INFO” from
the Main Menu and protect the data entered.
Any zone information entered will not be lost if this option is reset to 000 or N.
Resetting this option to 001 will allow access to zone information already entered.
14. Config Program
Setting this option to 001 to allow the changing of zones within a program.
On the edit program screen use the arrow keys to position the cursor on the zone number. The zone can then
be changed.
15. Program Percentage
Set this option to 001 to display “PROG PERCENT” in the Main Menu.
A percentage adjustment can be made for any individual program.
PROG 1 R001 C1-2
1 ZONE 01 VALVE 1 0:00
2 ZONE 02 VALVE 2 0:00
3 ZONE 03 VALVE 3 0:00
4 ZONE 04 VALVE 4 0:00
5 ZONE 05 VALVE 5 0:00
PROG PERCENT
PROG01 PERCENT 100 %
PROG02 PERCENT 100 %
PROG03 PERCENT 100 %
PROG04 PERCENT 100 %
PROG05 PERCENT 100 %
To Next Page
Loading...