HERON HT240 pro - Use Names; Number of Cycling Starts; Parallel Programs

29
The adjustment will be applied pro-rata for each zone within the irrigation program. For example, if a program
has 2 zones, zone 1 set to run for 6 minutes and zone 2 to run for 10 minutes. If the percentage adjustment
is set for 50%, then zone 1 will run for 3 minutes and zone 2 for 5 minutes.
Likewise, if the percentage adjustment is set to 200%. Then in example above, zone 1 would run for 12
minutes and zone 2 would run for 20 minutes.
WARNING: Leave the percentage value at 100% for programs to have their normal
run time. If the percentage value is left at 0%, the program will not run.
16. Use Names
Set this option to 001 to display the program name when the program is running.
17. Number of Cycling Starts
Set this option from 001 to 032 to specify the number of cycling starts required.
If this option is activated then “CYCLING START” will appear as an additional item on the Auto Menu.
Select “”CYCLING START” from the Auto Menu.
If this option has been set to a value greater than one, enter a number within the range specified in the option.
Specify the program to be cycled, the time of day to start and end cycling and any required delay between
cycles.
A cycling start must be enabled in order for it to work. The next start time will be displayed when the
cycling start is activated.
20. Parallel Programs
Set this option from 000 to 006 to specify the maximum number programs to run in parallel. The Heron
controller runs up to 6 programs in parallel. Up to 16 zones can be run in parallel with the addition of extra
cards.
CYCLING 1
PROG NUMBER 01
ENABLED NO
DAY START TIME 00:00
DAY STOP TIME 00:00
DELAY HRS MINS 00:00
NEXT START INVALID