Set Up or Edit Program Information
Select “EDIT PROGRAMS” from the Main Menu. The Program Menu will be displayed.
Select EDIT PROGS from the Program Menu.
The default configuration option is for your controller to have only 1 program, however your controller can run
up to 28 irrigation programs. The number of programs your controller can operate can be changed by setting
your controller configuration options. See section 15 “Changing Standard Configuration Options”.
If your controller has been set up to run multiple programs then select the program you want to edit by
changing the program number.
The default is for programs to be in minutes and seconds. Once again, this can be changed to hours and
minutes through the controller configuration options.
Press “OK/SELECT” and the following screen will be displayed.
Use the arrow keys to move the cursor over the zone “minutes” and “seconds” fields. Use the number keys
to set the run time required for each zone in the program.
EDIT PROG
---------------------------------
ENTER PROG 1
--------------------------------------------
NAME Grass01
RUN TIME 00:22:00 ZONE TIME MINSECS
PROG 1 R001 C1-2
1 ZONE 01 VALVE 1 0:30
2 ZONE 03 VALVE 3 1:00
3 ZONE 05 VALVE 5 0:00
4 ZONE 07 VALVE 7 0:00
5 ZONE 09 VALVE 9 0:00
PROG 1 R001 C2-2
1 ZONE 02 VALVE 2 1:00
2 ZONE 04 VALVE 4 2:00
3 ZONE 06 VALVE 6 0:00
4 ZONE 08 VALVE 8 0:00
5 ZONE 10 VALVE 10 0:00
To Next Page
Loading...