HID DTC1000 User Manual

Telnet Command Command Purpose Command Format
address.
mask Store a new address
mask.
store net mask <MASK>
gateway Store a new default
gateway.
store net gateway <ADDRESS>
dns Store a new DNS
server address.
store net dns <ADDRESS>
domain Store a new DNS
domain suffix.
store net domain <STRING>
opts Enable or disable
automatic address
assignment using
DHCP. Static (non-
automatic) addresses
will come from the
stored or default
settings, depending on
the other settings.
To enable automatic address
assignment:
store net opts dhcp
To disable automatic address
assignment:
store net opts -dhcp
from Restore the network
settings from either the
default settings or the
current settings.
store net from default|current
mode Specify the Ethernet
interface mode as:
automatic, full or half
duplex; 10 or 100 mHz.
store ifc mode
auto|10half|10full|100half|100full
ifc
from Set the Ethernet mode
settings from the
default or current
settings.
store ifc from default|current
save Save all current
settings as the stored
settings in the
permanent memory.
save
load Take the settings from
the stored memory and
make them the current
settings.
load
DTC1000/4000/4500 Ethernet User Guide – Installation Guide L001411 (Rev.1.0)
16

HID DTC1000 Specifications

General

Brand	HID
Model	DTC1000
Category	Printer
Language	English