Step Procedure
2 Select the link for the log name you want to view or configure (the default
choices are log1 or log2). See the previous page.
3 Enter a new log name in the textbox.
4 Click on the Submit button to save this change.
5 Log in as a root User if you are so prompted. (Note: Any change of a
setting will only be accepted after you have successfully logged in.)
Selecting the Log Type
Step Procedure
1 Select the System Log link. See the next page.
2 Select the link for the log name you want to view or configure (the default
choices are log1 or log2).
3 Select the Print Job Started checkbox to generate the log entries for each
Print Job Started.
DTC1000/4000/4500 Ethernet User Guide – Installation Guide L001411 (Rev.1.0)
32
To Next Page
Loading...
Need help?
General
