Resetting to Default Settings
The Reboot page also allows the User to reboot the Ethernet Print Server into a default
settings mode. (Note: This simply restarts the Printer in a different state with the
settings in memory temporarily ignored.)
When the Default button is selected, the stored settings in the Printer’s memory are not
changed.
Step Procedure
1 Select the Administration link.
2 Log in as a root User (using the password) if you are so prompted. (Note:
Any change of a setting will only be accepted after you have successfully
logged in.)
3 Select the Reboot link.
4 Select the Default button.
5 Wait for the Printer to reboot and display the home page.
DTC1000/4000/4500 Ethernet User Guide – Installation Guide L001411 (Rev.1.0)
43
To Next Page
Loading...
Need help?
General
