Step Procedure
1 Apply power to the Printer.
2 Ensure that the Printer is connected to your network.
3 Wait up to one (1) minute to allow the Printer to configure the IP address.
4 Scroll through the informational messages on the LCD by selecting the INFO
button (the button on the right of the front panel).
5 View the IP address displayed as a dotted quad number.
Example: 168.192.1.1
Reviewing the Telnet Command Table
The following table describes available Telnet commands. (Note: You can enter partial
full-word commands: the Printer will respond with additional help. For example, you can
enter list, and the Printer will respond with all subcommands to the list command.)
Telnet Command Command Purpose Command Format
?
help
Display help for Telnet
commands.
?
reset
Reset the Ethernet interface for
the Printer/Encoder.
reset
ping
Send a ping command to another
IP address as a test of the
Ethernet interface.
ping <IPADDR>
all Display all information about this
Printer.
list all
diff Display all differences between
current and stored network
settings.
list diff
uptime Display how long since the
interface was last reset.
list uptime
list
sysinfo Display information about the
Printer (i.e., model, label, contact,
location, Firmware version and
date, and serial number).
list sysinfo
DTC1000/4000/4500 Ethernet User Guide – Installation Guide L001411 (Rev.1.0)
13
To Next Page
Loading...
Need help?
General
