HID DTC1000 - Verifying that your PC can access the Printer using the ping command

Verifying that your PC can access the Printer using
the ping command
Step Procedure
1 Follow these instructions to issue a ping command to the Printer:
At a DOS prompt, enter ping [IP Address]
Example: C:\>ping 210.1.10.240
• If the ping response is successful, move on to the next troubleshooting
procedure. See Display A below.
• If the ping response is not successful, continue to step 2 of this
procedure. See Display B below.
Display A - Example of sending a ping to the Printer with a successful response
Display B - Example of ping timeout to an invalid IP address
Step Procedure
DTC1000/4000/4500 Ethernet User Guide – Installation Guide L001411 (Rev.1.0)
49