To Next Page

To Previous Page

Using the Print Path page

The purpose of the Print Path page is to allow the User to view or change the TCP port

numbers used to communicate to the printer. If these settings are left to the default

entry of 0 then the default ports of 9100, 5400 and 5402 will be used for the RawSocket

TCP Port, the CPS Data TCP Port and the CPS Command TCP Port respectively.

The CPS Command TCP Port is dependent on the setting of the CPS Data TCP Port

and always two units higher.

Step Procedure

1 Select the Print Path link.

2 View the active configuration of the printer in the Current Settings area on

this page.

3 New port numbers may be entered into the Stored Settings area in the

text boxes provided on this page.

Step Procedure

4 Select the Submit button to save these changes to stored settings in the

memory of the Printer. (Note: These settings will not be lost if the power

DTC1000/4000/4500 Ethernet User Guide – Installation Guide L001411 (Rev.1.0)

HID DTC1000 User Manual

Questions and Answers: