Question Answer
How do I
configure my
Printer’s IP
settings?
There is now a new way to choose a specific IP address for the
printer and to set the printer to use a static IP from the printer
itself.
From the network menu there is a "Set IP" and a "Set Subnet"
menu option.
Select "Set IP" from the printer to manually enter the static IP you
want to use. The left button decrements the currently highlighted
value, and the right button indexes the cursor to the next digit to
the right:
Once the index goes all the way to the right of the entire IP
address- a save screen will appear to save the address.
The left key will cancel the changes and the right key will save the
address. If you save the IP address and the printer had been in
DHCP (Dynamic address mode) then the printer will be changed
to disable DHCP and use this static address.
The "Set Subnet" is the exact same sequence to set and save a
subnet mask.
DTC1000/4000/4500 Ethernet User Guide – Installation Guide L001411 (Rev.1.0)
55
To Next Page
Loading...
