4-12 Capturing Presets Technobeam
®
User Manual
9. Press <Enter>. The scene created on the controller is now stored in the
selected scene number.
10. You will need to manually select values for the XFAD and DLAY
constructs, since the controller does not transmit those constructs.
Note
If the scene you captured to was previously
programmed, you will need to make that scene active in
order to view the newly-captured scene for the first time.
(To make the scene active, select the scene number from
the
EDIT
menu.)
11. Repeat the procedure for each fixture you want to capture presets to.
To Next Page
Loading...
