i Ecodome User Manual
Figure 1-1. Identifying yoke components. ..................................................... 1-8
Figure 1-2. Installing the yoke on the fixture. ............................................... 1-9
Figure 1-3. Removing the door allows you to access the fixture’s voltage
selection switches, as well as wheels and optics......................................... 1-11
Figure 1-4. The three voltage selection switches located next to the LED display.
1-11
Figure 1-5. Setting the fixture’s voltage and frequency.............................. 1-11
Figure 1-6. The lens tube contains the zoom lenses. ................................. 1-12
Figure 1-7. Squeeze the two latches on each side of the lens tube to open the cover.
1-12
Figure 1-8. Components of the factory-installed 11 to 17 degree lens set. 1-13
Figure 2-1. The initial LED menu display shows the fixture’s software version..
2-2
Figure 2-2. Location of the three status LEDs on the fixture’s access door... 2-3
Figure 2-3. Properly-constructed data cabling............................................... 2-5
Figure 2-4. Constructing a data cable terminator. ......................................... 2-6
Figure 2-5. Location of the DMX data in (male) and DMX data Out (female) ports
on the fixture’s rear panel............................................................................... 2-7
Figure 2-6. Connecting fixtures to a controller. Make sure you terminate the last
fixture in the link. ........................................................................................... 2-8
Figure 2-7. Use a locking washer when attaching a fixture to a truss. ....... 2-10
Figure 2-8. Always use a safety cable when mounting the fixture. ............ 2-11
Figure 2-9. Location of the T-handle you use to adjust the yoke position. 2-11
Figure 2-10. You can slide the yoke all the way back to allow the fixture to hang
upside-down. ............................................................................................... 2-12
Figure 2-11. Menu navigation buttons. ....................................................... 2-13
Figure 2-12. This fixture has software version 3........................................ 2-19
Figure 2-13. Location of the fixture’s exhaust vent. ................................... 2-21
Figure 3-1. Technobeam navigation buttons. ................................................ 3-2
Figure 4-1. Making sure the shutter is open. ................................................. 4-5
Figure 4-2. A dot always appears in the LED display whenever preset playback
is on. ..................................................................................................... 4-9
Figure 4-3. When you set up fixtures for synchronized playback on a DMX 512
link, one and only one fixture must be fixture number 1 or DMX start channel 1.
The last fixture on the link must be terminated.......................................... 4-10
Figure 5-1. The laser light exits the through the same aperture as the light beam.
5-4
Figure 5-2. The ideal position of the laser is no more than 2” (5 cm) directly
above the center point of a perfectly round light beam................................. 5-4
Figure 5-3. Removing the access door. .......................................................... 5-6
Figure 5-4. LAD wiring connections............................................................... 5-7
Figure 5-5. The laser aiming device circuit board. ........................................ 5-8
Figure 6-1. Removing the door allows you to access the fixture’s voltage
selection switches and fuses, as well as wheels and optics. .......................... 6-3
Figure 6-2. Locations of the three fuses on the circuit board........................ 6-4
Figure 6-3. Location of the wheels in Technobeam. ..................................... 6-5
To Next Page
Loading...