User Manual of DS-7200/7300/8100-SH Series DVR
133
Figure 9.7 PPPoE Settings Interface
3. Check the PPPoE checkbox to enable this feature.
4. Enter User Name and Password for PPPoE access.
Note: The User Name and Password should be assigned by your ISP.
Figure 9.8 PPPoE Settings Interface
5. Click the Apply button to save and exit the interface.
6. After successful settings, the system asks you to reboot the device to enable the new settings, and the
PPPoE dial-up is automatically connected after reboot.
You can go to Menu>Maintenance>System Info>Network interface to view the status of PPPoE
connection. Please refer to Chapter 12.1Viewing System Information for PPPoE status.
9.2.2 Configuring DDNS
Purpose:
If your device is set to use PPPoE as its default network connection, you may set Dynamic DNS (DDNS) to
be used for network access.
Prior registration with your ISP is required before configuring the system to use DDNS.
Steps:
1. Enter the Network Settings interface.
Menu > Configuration > Network
2. Select the DDNS tab to enter the DDNS Settings interface.
Figure 9.9 DDNS Settings Interface
3. Check the DDNS checkbox to enable this feature.
4. Select DDNS Type. Five different DDNS types are selectable: IPServer, DynDNS, PeanutHull,
NO-IP and HiDDNS.
• IPServer: Enter Server Address for IPServer.
Note: The Server Address should be the IP address of the PC that runs IPServer.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
