User Manual of DS-7200/7300/8100-SH Series DVR
72
Figure 5.22 Alarm Handling
Note: IP Camera is supported by HDVR series only.
5) Choose the alarm triggered recording channel.
6) Check the checkbox to select channel.
7) Click Apply to save settings.
8) Click OK to back to the upper level menu.
9) Click Apply in the Alarm Input interface to save the settings.
Repeat the above steps to configure other alarm input parameters.
If the setting can also be applied to other alarm inputs, click Copy and choose the alarm input number.
Figure 5.23 Copy Alarm Input
3. Enter Record Schedule settings interface (Menu> Record > Schedule > Record Schedule). For
detailed information about record schedule settings, refer to step 2 in Chapter 5.2 Configuring Record
Schedule.
Note: You need to select the Type as Alarm in record schedule settings.
To Next Page
Loading...
