HIKVISION DS-7100NI-Q1/P Series - Page 65

Add Non-PoE Network Camera
You can use the PoE channel resource to connect a non-PoE network camera.
Steps
1. Go to Conguraon → Camera → Camera → IP Channel .
2. Click
of a channel with no linked network camera.
3. Select Adding Method as Manual.
Plug-and-Play
The camera is physically connected to the PoE interface. You can click
in the added device
list to edit its parameters.
Manual
Add IP camera without physical connecon via network cable.
4. Set other parameters, such as user name, password, and IP address.
Congure
Channel Type
You can disable a PoE channel to addionally increase a normal IP channel resource.
Go to Conguraon → Camera → Camera → PoE Binding Conguraon , and set the PoE channel
as your desire.
Figure 6-17 PoE Binding Conguraon
Sort Channel Order
Go to
Conguraon → Camera → Camera . Refer to Sort Channel Order for details.
Congure
Remote Sengs
Go to Conguraon → Camera → Camera . Refer to Congure Remote Sengs for details.
Network Video Recorder User Manual
51