EasyManuals Logo
Home>HIKVISION>DVR>DS-7316HQHI-K4

HIKVISION DS-7316HQHI-K4 User Manual

HIKVISION DS-7316HQHI-K4
246 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #240 background imageLoading...
Page #240 background image
Digital Video Recorder User Manual
239
2) If the status of the HDD is Uninitialized, please check the checkbox of corresponding
HDD and click the Init button.
Step 3 Verify the HDD is detected or is in good condition.
1) Select “Menu>HDD>General”.
2) If the HDD is not detected or the status is Abnormal, please replace the dedicated HDD
according to the requirement.
Step 4 Check if the fault is solved by the step 1 to step 3.
1) If it is solved, finish the process.
2) If not, please contact the engineer from our company to do the further process.
Live view stuck when video outputs locally.
Possible Reasons:
The frame rate has not reached the real-time frame rate.
Step 1 Check the parameters of Main Stream (Continuous) and Main Stream (Event).
Select Menu > Record > Parameters > Record, and set the resolution of Main Stream
(Event) the same as the one of Main Stream (Continuous).
Step 2 Verify the frame rate is real-time frame rate.
Select Menu > Record > Parameters > Record, and set the Frame Rate to Full Frame.
Step 3 Check if the fault is solved by the above steps.
If it is solved, finish the process.
If not, please contact the engineer from our company to do the further process.
When using the device to get the live view audio, there is no sound or there is too much noise,
or the volume is too low.
Possible Reasons:
Cable between the pickup and camera is not connected well; impedance mismatches or
incompatible.
The stream type is not set as Video & Audio.
Step 1 Verify the cable between the pickup and camera is connected well; impedance matches and
compatible.
Step 2 Verify the setting parameters are correct.
Select Menu > Record > Parameters > Record, and set the Stream Type as Audio &
Video.
Step 3 Check if the fault is solved by the above steps.
If it is solved, finish the process.
If not, please contact the engineer from our company to do the further process.
The image gets stuck when DVR is playing back by single or multi-channel cameras.

Table of Contents

Other manuals for HIKVISION DS-7316HQHI-K4

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HIKVISION DS-7316HQHI-K4 and is the answer not in the manual?

HIKVISION DS-7316HQHI-K4 Specifications

General IconGeneral
Product colorBlack
Channels quantity16 channels
Video compression formatsH.264, H.264+, H.265, H.265+
Analog signal format systemNTSC, PAL
Playback resolutions supported3840 x 2160, 2560 x 1440, 1920 x 1080, 1280 x 1024, 1280 x 720, 1024 x 768
Ethernet LANYes
Ethernet interface typeGigabit Ethernet
Ethernet LAN (RJ-45) ports1
Supported network protocolsTCP/IP, PPPoE, DHCP, Hik-Connect, DNS, DDNS, NTP, SADP, NFS, iSCSI, UPnP, HTTPS, ONVIF
HDD interfaceSerial ATA
Maximum HDD capacity8000 GB
Number of HDDs supported4
Power requirements100 - 240 VAC
Power consumption (typical)55 W
Operating temperature (T-T)-10 - 55 °C
Operating relative humidity (H-H)10 - 90 %
Weight and Dimensions IconWeight and Dimensions
Weight5000 g
Dimensions (WxDxH)445 x 390 x 70 mm

Related product manuals