95
2. Configure RS-232 Settings.
3. The RS-232 port can be used in two ways:
• Parameter Control: Connect a PC to the DVR using the PC serial port. Device parameters can
then be set using software such as HyperTerminal. The serial port parameters must be the same as
the DVR’s when connecting with the PC serial port.
• Transparent Channel: Connect a serial device directly to the DVR. The serial device will be
controlled remotely by the PC through the network and the protocol of the serial device.
Note: Please note that the remote control features through the RS-232 port are limited.
Managing User Accounts
By default, your DVR comes with one user account, the Administrator account. The Administrator user name is admin
and the password is 12345. The default password for Administrator should be changed right away for security reasons.
The Administrator has the authority to add, delete or configure parameters for many of the system functions.
Adding a New User
You may add up to 31 new users to your DVR. To add new users:
Enter the User Settings menu, shown in Figure 4 by clicking Menu > Setting > User.
Figure 4. User Settings Menu
1.
Select the Add button to enter the Add User menu, shown in Figure 5.
To Next Page
Loading...
Need help?
General