52
Configuring Alarms
Setting up Motion Detection
Set up properly, using motion detected recording will increase the number of days your DVR is able to record. It will
only record relevant events rather than recording everything, making searching for an event easier.
To set up motion detection:
1. Enter Camera Management/Setting:
• Using a DS-9000 Series DVR: Enter the Camera Management interface, shown in Figure 1 by
navigating to Menu > Setting > Camera. Select the channel to configure motion detection on and
click Set.
Figure 1. Camera Management Interface
• Using a DS-9100 Series DVR: Enter the Camera Settings interface by navigating to Menu >
Setting > Camera. Select channel to configure motion detection on.
2. Select the Advanced tab to open up the Advanced Camera Settings menu, shown in Figure 2.
To Next Page
Loading...
Need help?
General