HIKVISION DS-96000NI-M8 Series - Queue Management; Target Detection

6.2.20 Queue Management
Aer connecng with queue management camera, you can set the arming schedule and linkage
acon of queue management.
Before You Start
Ensure the recorder have connected with queue management camera.
Steps
1. Go to Smart Analysis → Smart Event Sengs → Other Events .
2. Select a queue management camera.
3. Oponal: Check Save VCA Picture to save the captured pictures of detecon.
4. Set the arming schedule. Refer to Chapter Congure Arming Schedule for details.
5. Set the linkage acons. Refer to Chapter Congure Linkage Acons for details.
6. Click Apply.
6.2.21 Target
Detecon
In live view mode, the target detecon funcon can achieve smart detecon, facial detecon,
vehicle detecon, and human body detecon during the last 5 seconds and the following 10
seconds.
Steps
1. In Live View mode, click Target Detecon to enter the target detecon interface.
2. Select
dierent detecon types: smart detecon ( ), vehicle detecon ( ), facial detecon
( ), and human body detecon ( ).
Note
For thermal cameras, the temperature measurement event is in mart detecon ( ), the face
capture and facial temperature measurement are in facial detecon ( ).
3. Select the historical analysis ( ) or real-me analysis ( ) to obtain the results.
Note
The smart analysis results of the detecon are displayed in the list. Click a result in list to play
the related video.
4. Oponal: You can select channels that require picture capture. The unselected channels will not
capture picture.
1) Click
at the le boom of live view interface.
2) Select channel(s), the checked channel(s) will capture picture. All channels are selected as
default.
3) Click Finish.
Network Video Recorder User Manual
72