HIKVISION DS-96000NI-M8 Series - Sudden Scene Change Detection; PIR Alarm

6.2.17 Sudden Scene Change Detecon
Scene change detecon detects the change of the video security environment aected by external
factors, such as the
intenonal rotaon of the camera.
Steps
1. Go to Smart Analysis → Smart Event Sengs → Other Events .
2. Select a camera.
3. Click Sudden Scene Change.
Figure 6-18 Sudden Scene Change
4. Check Enable.
5. Oponal: Check Save VCA Picture to save the captured sudden scene change detecon pictures.
6. Set the
detecon sensivity.
Sensivity
Ranges from 1 to 100, the higher the value, the more easily the change of scene can trigger
the alarm.
7. Set the arming schedule. Refer to
Congure Arming Schedule .
8. Set the linkage
acons. Refer to Congure Linkage Acons .
9. Click Apply.
6.2.18 PIR Alarm
A PIR (Passive Infrared) alarm is triggered when an intruder moves within the detector vision eld.
The heat energy dissipated by a person or any other warm blooded creature such as dogs, cats,
etc., can be detected.
Network Video Recorder User Manual
70