HIKVISION DS-96000NI-M8 Series - Configure Vehicle Detection

Figure 6-5 Face Capture
3. Select a camera to congure.
4. Check Enable Face Capture.
5. Oponal: Check Save VCA Picture to save the captured pictures of face detecon.
6. Set the detecon sensivity.
Note
Sensivity range: [1-5]. The higher the value is, the easier faces will be detected.
7. Set the arming schedule. Refer to Congure Arming Schedule .
8. Set linkage acons. Refer to Congure Linkage Acons .
9. Click Apply.
6.2.3
Congure Vehicle Detecon
Vehicle detecon, available in the road trac monitoring, is tend to detect the passed vehicle on
the road, and capture its license plate at the same me.
Steps
1. Go to Smart Analysis → Smart Event Sengs → Vehicle Detecon .
2. Select a camera.
3. Click Vehicle.
4. Check Enable Vehicle
Detecon.
5.
Oponal: Check Save VCA Picture to save the captured vehicle detecon pictures.
6. Congure rules, including Area Sengs, Picture, Overlay Content, and Blocklist and Allowlist.
Area
Sengs
Up to 4 lanes are selectable.
Network Video Recorder User Manual
55