HIKVISION DS-96000NI-M8 Series - Configure the Linkage Action and Arming Schedule; Configure OSD

Note
For access control devices without the video channel. You need to select trigger channel in
linkage acon conguraon rst. For details, refer to Congure Linkage Acons .
.
●
Click to edit added alarm device informaon.
2.2 Congure the Linkage Acon and Arming Schedule
Congure the linkage acons and arming schedule for access control or alarm devices. Linkage
acons will be triggered when the designate alarm occurs.
Steps
1. Click
of an added IoT device.
Figure 2-4 Congure IoT
2. Select Event Type. The following conguraon is only valid for the selected event type.
3. Check Enable.
4. Check linkage
acons as your desire. For detailed steps, refer to Congure Linkage Acons .
Note
Full Screen Monitoring and OSD Display are only valid for the selected Trigger Channel.
5. Click Arming Schedule.
6. Congure arming schedule. For detailed steps, refer to Congure Arming Schedule . Linkage
acon is only valid during the set schedule.
7. Click Apply.
2.3
Congure OSD
You can display alarm informaon received from IoT devices on live view image.
Network Video Recorder User Manual
18