HIKVISION DS-96000NI-M8 Series - Thermal Camera Detection

Steps
1. Go to Smart Analysis → Smart Event Sengs → Other Events .
2. Select a camera.
3. Click PIR Alarm.
Figure 6-19 PIR Alarm
4. Check PIR Alarm.
5. Oponal: Check Save VCA Picture to save the captured of PIR alarm pictures.
6. Set the arming schedule. Refer to Congure Arming Schedule .
7. Set the linkage
acons. Refer to Congure Linkage Acons .
8. Click Apply.
6.2.19 Thermal Camera
Detecon
The NVR supports the event detecon modes of the thermal network cameras: re and smoke
detecon, temperature detecon, temperature dierence detecon, etc.
Before You Start
Add the thermal network camera to your device and make sure the camera is
acvated.
Steps
1. Go to Smart Analysis → Smart Event
Sengs → Other Events .
2. Select a thermal camera.
3. Oponal: Check Save VCA Picture to save the captured pictures of detecon.
4. Select an event detecon (Temperature Measurement Alarm, etc.).
5. Set the arming schedule. Refer to Congure Arming Schedule .
6. Set the linkage
acons. Refer to Congure Linkage Acons .
7. Click Apply.
Network Video Recorder User Manual
71