HIKVISION DS-96000NI-M8 Series - Security Management; IP;MAC Address Filter

Restore all parameters, except the network (including IP address, subnet mask, gateway,
MTU, NIC working mode, default route, server port, etc.) and user account parameters, to the
factory default sengs.
Factory Defaults
Restore all parameters to the factory default sengs.
Restore to Inacve
Restore the recorder to inacve status.
Note
The recorder will reboot automacally aer restoring to the default sengs.
13.9 Security Management
13.9.1 IP/MAC Address Filter
The address lter decides whether to allow or forbid specic IP/MAC address to get access to your
device.
Steps
1. Go to Maintenance → System Service → Address Filter .
Figure 13-20 Address Filter
2. Check Enable.
3. Select Restricon Mode. Choose to lter by IP address or MAC Address.
4. Select
Restricon Type. The device mechanism will allow or forbid specic IP/MAC address to
get access to your device.
5. Oponal: Set Restricon List. You can add, edit or delete address.
6. Click Apply to save the
sengs.
Network Video Recorder User Manual
131