HIKVISION DS-96000NI-M8 Series - PTZ Control; Configure PTZ Parameters; Set a Preset

4.5 PTZ Control
4.5.1 Congure PTZ Parameters
Follow these procedures to set the PTZ parameters. The PTZ parameters conguraon must be
done before you can control the PTZ camera.
Steps
1. Click
on the quick sengs toolbar of the PTZ camera.
2. Click PTZ Parameters Sengs to set the PTZ parameters.
Figure 4-5 PTZ Parameters Sengs
3. Edit the PTZ parameters.
Note
All the parameters should be exactly match the PTZ camera parameters.
4. Click OK to save the sengs.
4.5.2 Set a Preset
Presets record the PTZ posion and the status of zoom, focus, iris, etc. You can call a preset to
quickly move the camera to the predened posion.
Steps
1. Click on the quick sengs toolbar of the PTZ camera's live view.
2. Click direconal buons to wheel the camera to a locaon.
3. Adjust the zoom, focus and iris status.
4. Click in the lower right corner of Live View to set the preset.
Network Video Recorder User Manual
33