HIKVISION DS-D6043FN-B User Manual

Steps
1. Log into FocSign Client.
2. Click Terminal in the menu bar.
3. Click
in Online Device to view online terminals.
4.
Select the terminal to be
acvated.
5. Click Acvaon.
Figure 3-7 Acvate Terminal
6. Set the terminal password and conrm password.
7. Click OK.
8. Oponal: Edit network parameters of the terminal.
1) Select Terminal → Terminal
Conguraon → Terminal Network .
2) Enter and edit network parameters such as IP Address, Subnet Mask and Gateway.
3) Click OK.
3.3.2
Acvate on the Mobile Phone
Steps
Note
• Before
acvang terminals, please ensure that SADP is enabled on the terminals. When the
SADP is disabled, there are no QR code on the terminal.
• The APP and the terminal must be in the same network segment. If a router exists, and the
terminal is connected to the router with the network cable, the mobile phone must be in the Wi-
Fi network environment provided by the same router.
• Please refer to FocSign Client user manual to
acvate or register terminals in dierent network
segments with the APP.
1. Log into FocSign Mobile.
2. Tap
on the upper right corner of the Terminal interface to scan the QR code of the terminal.
Digital Signage Quick Start Guide
9

HIKVISION DS-D6043FN-B Specifications

General

Brand	HIKVISION
Model	DS-D6043FN-B
Category	Digital Signage
Language	English