HIKVISION DS-k2210 User Manual

Main Elevator Controller User Manual
14
Chapter 5 Activation
Purpose:
You are required to activate the device first before using it.
Activation via the web client, activation via SADP, and activation via client software are supported.
The default values of the control terminal are as follows.
 The default IP address: 192.0.0.64.
 The default port No.: 8000.
 The default user name: admin.
5.1 Activating via Web Client
Steps:
1. Open the web browser.
2. For your first login, input the IP address of the main elevator controller to enter device
activation interface.
3. Input the password and confirm the password.
STRONG PASSWORD RECOMMENDED– We highly recommend you create a strong
password of your own choosing (using a minimum of 8 characters, including upper case
letters, lower case letters, numbers, and special characters) in order to increase the
security of your product. And we recommend you reset your password regularly,
especially in the high security system, resetting the password monthly or weekly can
better protect your product.
4. Click OK to activate the device. You will login the web client automatically.
Note: The device IP segment should be the same with the PC’s.
5.2 Activating via SADP Software
Purpose:
SADP software is used for detecting the online device, activating the device, and resetting the

HIKVISION DS-k2210 Specifications

General

DC input voltage	12 V
Power source type	DC
Housing color	Gray
Relay outputs	5

Weight and Dimensions

Depth	167 mm
Width	105 mm
Height	30 mm