HIKVISION DS-KD8003 Series - Page 110

Figure 6-22 Door Parameters
2.
Select Door No., and edit the Name.
3.
Set Open Duraon. When the me to open over the open duraon you set, the door will be
locked again.
4.
Select Relay Reverse as ON or Disable.
5.
Click Save to enable the
sengs.
Elevator Control
Before You Start
Make sure that the door
staon is in the mode of main door staon. Only the main door staon
supports elevator control funcon.
Steps
1.
Click Access Control → Elevator Control Parameter to enter the sengs page.
DS-KD8003 Series Module Door Staon User Manual
102