HIKVISION DS-KD8003 Series User Manual

Figure 6-23 Elevator Control
2.
Check to enable elevator control funcon.
3.
Select an Elevator No., and select an elevator controller.
4.
Select Interface Type.
5.
Enter
Negave Floor Capacity, and select Alarm Receiver Type.
6.
Enter the elevator controller's Server IP Address, Port No., User Name, and Password.
7.
Click Save to enable the
sengs.
DS-KD8003 Series Module Door Staon User Manual
103

HIKVISION DS-KD8003 Series Specifications

General

Ingress Protection	IP65
Operation System	Embedded Linux
Camera	2MP
Video Compression Standard	H.264
Resolution	1920 x 1080
Video Input	1 channel
Video Output	1 channel
Audio Input	Built-in microphone
Audio Output	Built-in speaker
Audio Compression Standard	G.711
Audio Compression Rate	64 Kbps
Ethernet	10/100 Mbps
Network Protocol	TCP/IP
RS-485	1 channel
Alarm Input	1 channel
Debug Port	1 channel
TF Card	Support up to 128GB
Installation	Wall-mounted
Power Supply	12 VDC
Working Humidity	10% to 90% (No Condensation)
Network Interface	RJ45
Working Voltage	12 VDC