HIKVISION DS-KD8003 Series

Steps
1.
Paste the installaon Scker 1 onto the wall. Make sure the scker is placed horizontally via
measuring with the gradienter.
2.
Drill 4 holes according to the screw holes on the
scker. The suggested size of hole is 6
(diameter) × 25 (depth) mm. The suggested length of cables
le outside is 270 mm.
Figure 4-15 Drill Screw Holes
3.
Remove the scker and insert the expansion sleeves into the screw holes.
4.
Fix the mounng frame onto the wall with 4 expansion bolts.
Figure 4-16 Fix the Mounng Frame
5.
Thread the module-connecng line across the thread hole of the frame. Pass the main unit
connecng lines across the thread hole to the upper grid.
DS-KD8003 Series Module Door Staon User Manual
31