HIKVISION DS-TCG227-A Series User Manual

User Manual of DS-TCG227-A Series Entrance/Exit Capture Unit
32
Figure 6-12 Port Settings
2. Set the HTTP port, RTSP port, and SDK port of the capture unit.
HTTP Port: The default port number is 80, and it can be changed to any port No.
which is not occupied.
RTSP Port: The default port number is 554 and it can be changed to any port No.
ranges from 1024 to 65535.
SDK Port: It is reserved.
3. Click Save to save the settings.
A reboot is required for the settings to take effect.
6.3.2.5 Configure HTTPS Settings
Purpose:
HTTPS provides authentication of the web site and associated web server that one is
communicating with, which protects against Man-in-the-middle attacks. Perform the
following steps to set the port number of https.
Example
If you set the port number as 443 and the IP address is 192.168.1.64, you may access
the device by inputting https://192.168.1.64:443 via the web browser.
The HTTPS port can be only configured through the web browser.
1. Go to Configuration > Device Configuration > System Configuration >
HTTPS.

HIKVISION DS-TCG227-A Series Specifications

General

Brand	HIKVISION
Model	DS-TCG227-A Series
Category	Security Camera
Language	English